Wi-Fi 7 REPEATER 3600
All questions
Credentials and Web UI access
What is the Web UI password and how do I create it?
The first time you open http://setup.strong, the repeater asks you to create a login password. Enter a password of at least 8 characters combining uppercase letters, lowercase letters, digits and at least one special character from @ $ ! % * ? &, then confirm it and click Commit.
Warning: Write this password down and keep it in a safe place. It is the only way to access the Web UI. If it is lost, the only remedy is a factory reset, which erases all settings.
How do I reach the Web UI once the repeater is connected to my home network?
From any device connected to the extended network or to the Ethernet port, open a browser and go to http://setup.strong. You can also use the IP address the repeater received from your router (visible in System Status > LAN, or in your router's DHCP client list). Enter your Web UI password and click Login.
Tips: The Web UI is on your local network only — it is not reachable from the Internet. If http://setup.strong does not resolve, try the fallback address http://192.168.1.254 while connected directly to the repeater's own network (before it joined your router).
How do I rename the extended network or change its password?
Log in to the Web UI, go to General Settings > Wireless 2.4G (or Wireless 5G), change the SSID or the Security Key, and click Apply. Your devices will need to reconnect using the new name or password.
I have forgotten the Web UI password. What can I do?
You must perform a factory reset. With the repeater powered on, insert a paper clip or pin into the Reset pinhole on the side panel and hold it for about 10 seconds until the Power LED flashes. The repeater resets to factory defaults and starts up with no password. Reconnect to the STRONG_Repeater network and go to http://setup.strong to create a new password.