LEDs, buttons and ports

Why do the Powerlines switch off on their own?

This is normal: the Powerline 1000 Mini automatically switches to sleep mode if no activity is detected. When a signal is detected on the Ethernet port, the Powerline 1000 Mini turns back on. It may take a few seconds for a Powerline 1000 Mini in standby mode to detect new activity and turn back on.

The automatic power saving mode reduces your consumption by up to 85%.

Create a new Wi-Fi Hotspot at a speed up to 750 Mbps in minutes by using your existing electrical wiring and any power socket!

Do you have trouble covering some areas of your home with Wi-Fi? Do you need Wi-Fi in your loft, attic, basement or garden?

Simply connect the Powerline 1000 Mini adapter to your existing Internet modem through an Ethernet port and you will immediately have an Internet connection available at any power socket. Then, by using a Powerline 1000 Wi-Fi Mini adapter, you can create two new Wi-Fi hotspots (2.4 GHz and 5 GHz) in the room of your choice and extend your Wi-Fi home coverage in minutes. The 2.4 GHz Wi-Fi hotspot has a speed of up to 300 Mbps. The 5 GHz Wi-Fi hotspot has a speed of up to 433 Mbps.

I do not have access to the Internet and/or the LED of the "home" icon does not light up.

You must reset the adapters to their factory settings. To reset the adapters, please follow the steps below.

1Put the adapters on a power strip

Connect the adapters one after the other to a power strip.

2Connect the adapters to the Internet

Connect each adapter to a working device (Internet router/gateway, Android box, Smart TV, computer, etc.) with an Ethernet cable. There must be communication between the devices, otherwise the adapter will automatically go into standby mode.

3Press the Connect & Secure button (first adapter)

Once the adapter is plugged in and connected to the Ethernet, press the Connect & Secure button on the right side of the device for 15 seconds.

4Press the Connect & Secure button (second adapter)

Press the Connect & Secure button located on the right side of the second device for 15 seconds.

5The home LEDs blink

The home LEDs should start blinking.

6The adapters are reset

All the LEDs must be green at the end of the operation.

Repeat the same operation for a third powerline. You can have up to eight Powerline 1000 Mini adapters on the same electrical installation. After resetting all the devices, you can put them in the rooms where you need them.

Internet everywhere from any power socket!

The Powerline 1000 Duo Wi-Fi Mini, which includes a Powerline 1000 Mini adapter and a Powerline 1000 Wi-Fi Mini adapter, creates a high-speed home network effortlessly by using your home's existing electrical wiring at speeds up to 1000 Mbps.

No new wire is required! Connect computers, consumer electronics and network-compatible devices to the Internet in any room and on any floor of your home by simply using a power outlet.

The home icon LED is lit on the Wi-Fi adapter, but I cannot connect to the Wi-Fi network of the Powerline 1000 Wi-Fi Mini.

1Connect to the Wi-Fi network of your powerline

To connect to the Powerline 1000 Wi-Fi Mini for the first time, you must connect to the SSID indicated on the back of the product and use the Wi-Fi password indicated.

Please note that the lowercase l can be confused with the uppercase I, so please try the different possibilities.

2Reset the Powerline 1000 Wi-Fi Mini adapter

Reset the Powerline 1000 Wi-Fi Mini by pressing the reset button located next to the Ethernet port with a paper clip until the Wi-Fi LED flashes.

What do the icons and LEDs on the Powerline mean?

This illustration shows the different statuses of the Powerline 1000 Mini adapter LEDs.

This illustration shows the different statuses of the Powerline 1000 Wi-Fi Mini adapter LEDs.