TNT SAT | FHD satellite receiver 7410 with access card (FR)
All questions
TNT SAT | FHD satellite receiver 7410 with access card (FR)
Reset, reboot and firmware update
How do I perform a factory reset?
A factory reset resolves most common issues. Follow these steps exactly:
1Open Factory Settings
Menu > Advanced (Avancé) > OK > Factory Settings (Réglage usine) > OK, then enter PIN code 2004. The receiver switches off and restarts on the language selection screen.
2Language and preferences
Choose your language and press OK. Set the preferences matching your installation, then press OK.
3Parental control
Set Menu Lock to 'Disabled', Maturity Level to '18 years', then press OK. Enter your 4-digit PIN code and confirm it — write it down.
4Signal check
Signal bars for STRENGTH and QUALITY appear. Make sure you have at least 90% on both (green bars). If not, adjust your dish alignment.
5Channel scan
Press OK to launch the channel scan when the signal is good, select your regional France 3 channel and press OK. The receiver starts on channel 1.
Warning: A factory reset erases all channel lists, settings and timers. The TNTSAT card rights are stored on the card itself and are NOT affected.
How do I update the firmware manually via USB?
Download the firmware for SRT7410 from www.strong-eu.com/downloads. Copy the file to the root of a FAT32 USB stick. Connect it to the receiver. Go to Menu > Advanced > Update (Mise à jour), press OK twice, then press RED (Update Software / Mise à jour Logiciel). The receiver restarts automatically after the update.
How does automatic firmware update work?
Every time the receiver starts, it checks for a software update via satellite (OTA). If a new version is found, you will be prompted to confirm. Accept the update when prompted.
Tips: You cannot refuse an OTA update more than twice. If rejected twice, the update will start automatically on the next power-on.
Warning: Never disconnect the power or the antenna cable during a firmware update.