LEDs, buttons and ports

My Powerline adapters switch off on their own. Is this normal?

Yes. The Powerline 600 Duo Wi-Fi Mini has an automatic power-saving mode that reduces energy consumption by up to 85%. When no activity is detected on the Ethernet port, the adapter goes into standby. It wakes up automatically when a signal is detected again, which can take a few seconds.

If the adapter goes into standby when you don't expect it, check the following:

• The device connected to the adapter by Ethernet (router, computer, TV box) must be switched on. Standby is triggered when that device is off or asleep.
• The Ethernet cable must be firmly connected at both ends.
• When pairing adapters (High Security Level 2) or resetting them, each adapter must be connected by Ethernet to a working device. Otherwise it may go into standby during the procedure.

Create a new Wi-Fi Hotspot at a speed up to 300 Mbps in minutes by using your existing electrical wiring and any power socket!

Do you have trouble covering some areas of your home with Wi-Fi? Do you need Wi-Fi in your loft, attic, basement or garden?

Simply connect the Powerline 600 Mini adapter to your existing Internet modem through an Ethernet port, and you will immediately have an Internet connection available at any power socket at a speed of up to 600 Mbps. Then, by using a Powerline 600 Wi-Fi Mini adapter, you can create a new Wi-Fi hotspot at a speed of up to 300 Mbps in the room of your choice and extend your Wi-Fi home coverage in minutes.

I do not have access to the Internet and/or the LED of the "home" icon does not light up.

You must reset the adapters to their factory settings. To reset the adapters, please follow the steps below.

1Plug the adapters into a power strip

Connect the adapters one after the other to a power strip.

2Connect the adapters to the Internet

Connect each adapter to a working device (Internet router/gateway, Android box, Smart TV, computer, etc.) with an Ethernet cable. There must be communication between the devices, otherwise the adapter will automatically go into standby mode.

3Press the Connect & Secure button (first adapter)

Once the adapter is plugged in and connected to the Ethernet, press the Connect & Secure button on the right side of the device for 15 seconds.

4Press the Connect & Secure button (second adapter)

Press the Connect & Secure button on the right side of the second device for 15 seconds.

5The home LEDs blink

The home LEDs should start blinking.

6The devices are reset

All the LEDs must be green at the end of the operation.

Repeat the same operation for a third powerline. You can have up to eight Powerline 600 Mini adapters on the same electrical installation. After resetting all the devices, you can put them in the rooms where you need them.

Internet everywhere from any power socket!

The Powerline 600 Duo Wi-Fi Mini, which includes a Powerline 600 Mini adapter, creates a high-speed home network effortlessly by using your home's existing electrical wiring at speeds up to 600 Mbps. No new wire is required! Connect computers, consumer electronics and network-compatible devices to the Internet in any room and on any floor of your home by simply using a power outlet.

The home icon LED is lit on the Wi-Fi adapter, but I cannot connect to the Wi-Fi network of the Powerline 600 Wi-Fi Mini.

1Connect to the Powerline Wi-Fi network

To connect to the Powerline 600 Wi-Fi Mini for the first time, you must connect to the SSID indicated on the back of the product and use the Wi-Fi password indicated.

Please note that the lowercase l can be confused with the uppercase I, so please try the different possibilities.

2Reset the Wi-Fi adapter

Reset the Powerline 600 Wi-Fi Mini by pressing the Connect & Secure button for 10 seconds.

What do the icons and LEDs on the Powerline mean?

This illustration shows the different statuses of the Powerline 600 Wi-Fi Mini LEDs.

This illustration shows the different statuses of the Powerline 600 Mini LEDs.