Universal Repeater 300 V2

No items found.

No items found.

All questions

Universal Repeater 300 V2

Will the MAC address-filtering settings configured on my modem/router be effective if I use Universal Repeater 300 to extend the Wi-Fi network of my modem/router?

Will the MAC address-filtering settings configured on my modem/router be effective if I use Universal Repeater 300 to extend the Wi-Fi network of my modem/router?

Which frequencies are used to create a connection between the router/modem and Universal Repeater 300?

Which Wi-Fi frequencies (bands) does Universal Repeater 300 provide?

What is the meaning of the LEDs of my repeater?

What is the best location for the Universal Repeater 300?

What is the IP address of Universal Repeater 300?

What can I do in the Web UI?

What are the credentials to access the Web UI?

I installed my Universal Repeater 300 as a Repeater, but only the Wi-Fi LED is on, why?

I installed my Universal Repeater 300 as a Repeater but my broadband Internet speed is not improved, why?

I have a guest network on my modem/router. Can I extend my router's guest network as well as the main Wi-Fi network with a Universal Repeater 300?

I cannot find my existing Wi-Fi network in the Installation Wizard of the Universal Repeater 300, why?

I cannot access the Web UI with the URL (http://strong.ap300) when I am setting up the device, why?

I cannot access the Web UI (http://strong.ap300) of my repeater after completing its setup, why?

I have configured MAC address filtering rules on my router. Can I still use the Universal Repeater 300 to extend the Wi-Fi network of my modem/router?

How do I update the firmware of my repeater?

How do I reset my repeater to its factory settings? (Web UI)

How do I reset my Universal Repeater 300 to its factory default settings? (Reset button)

How do I change the default admin password of my repeater?

How do I access the Web UI?

How do I access the Web UI after the configuration?

How can I set up Universal Repeater 300 as an Access Point?

How can I set up Universal Repeater 300 as a router?

How can I connect my device to my Universal Repeater 300 for the installation?

How can I change the settings of the repeater?

Can I change the Wi-Fi channels of Universal Repeater 300 at repeater mode?

No items found.

No items found.

I have configured MAC address filtering rules on my router. Can I still use the Universal Repeater 300 to extend the Wi-Fi network of my modem/router?

Yes, you can, but you need to allow the MAC addresses (MAC Address and 2.4 GHz BSSID) of Universal Repeater 300 at the MAC address filtering settings of your router. The MAC addresses (MAC Address and 2.4 GHz BSSID) of Universal Repeater 300 can be found at the “Device Status” section on its web management interface (http://strong.ap300)

Follow us